Furnace Ignition and Pilot Light Repair in Franklin, OH Near Me

Many furnaces have a red or yellow reset button on the motor housing or control board. Turn power off at the breaker first, locate the button, and press it once. Restore power and test. Avoid repeated resets, as this can mask a serious problem such as a failing motor or overheating limit switch. In Franklin, OH winters, repeated tripping usually means airflow is blocked or the heat exchanger is cracked.

Thermostat won't turn the furnace on? Here is what is usually behind it. Blank screen: swap the batteries. If it stays dark, the thermostat has probably lost its 24-volt supply, often from a blown low-voltage fuse on the furnace control board. Screen lit, no heat: confirm it is set to heat and no schedule or hold is overriding it. Make sure the furnace door is seated, since its safety switch cuts power when loose. Look for a tripped condensate float switch too. Stop and get a professional if a replacement fuse blows again. That fuse is a symptom of a short in the thermostat wiring, not a part to keep swapping. If you smell burning or see scorched wire, shut the furnace off at the breaker now. Pre-1990 Franklin, OH homes often lack a common wire, which is why many smart thermostat installs fail. Pro HVAC is a referral service connecting Ohio homeowners with local HVAC pros. Call (321) 463-9811.

A weak thermocouple or drafts around the burner compartment usually cause the pilot to extinguish. First, ensure the furnace door is fully closed and the area around the unit is free of strong air currents. If the pilot still will not stay lit after relighting per the label instructions, turn the gas valve off and do not attempt further adjustments.

Check the thermostat batteries and confirm the switch is set to heat. Replace the furnace filter if it is dirty, then verify the breaker is on. If the furnace still does not respond, turn the system off at the breaker to prevent further damage. Call (321) 463-9811 for referral to a local technician who can diagnose the issue safely.

A mini split head that runs but will not cool usually has a low refrigerant charge from a flare-joint leak, a blocked outdoor coil, or a failed fan or compressor capacitor. Water dripping from the indoor head is almost always the condensate drain, which relies on a gravity fall or a small pump that clogs with biofilm. A blinking timer or operation light is a stored fault code that tells a technician which sensor or board is reporting. In Franklin, OH these units often serve additions, attics and finished basements where they are the only heating or cooling in the room.